Setra Systems Super Count Spécifications télécharger pdf (Page 16)

Setra Super Count

Operator's Manual

3. Place the requested number of pieces on the pan. Press the count key. [To begin accumulat-

ing counts, clear the count accumulator by pressing 0 accum.]

NOTE: (If you press 0 accum while in the weighing mode, you will clear the weight accumulator.)

4. Add (or remove, if kitting) the desired pieces.

5. Press the accum key. The count is added into the accumulator and the total accumulated

count is then displayed.

6. Press the clear key to display the count currently on the scale pan.

7. Repeat steps 4-6 anytime you wish to add to the accumulated count.

8. Press the display, accum keys. The number of pieces shown is the total number accumulated.

NOTE: Pressing reset or — clear will clear the contents of both accumulators.

USE OF THE “INT” MODE

The Setra Super Count automatically adjusts the display update rate to provide stable performance

under environmental conditions such as vibration or draft. However, certain applications may require

that a fixed display update rate be set. When weighing in the presence of vibration or draft a slower

display update will provide a more stable reading. When filling containers to a target weight or count,

a fast display update can help prevent overshooting the target.

Either a slow or fast display update is available when the scale is in the INT mode. The factory default

setting for the INT mode is a fast display update. Refer to the Setup Functions in Appendix II to alter

the mode from fast to slow. To enter the INT mode, press the int key. The INT symbol will appear in the

display. Exit this mode by repressing the int key. This mode can be used while performing weighing

or counting operations.

ASSIGNING AN I.D. NUMBER TO A BATCH

To assign an ID number (such as a part number or an account number) to a given batch, use the

following procedure:

1. Enter the number you wish to assign (up to 25 digits).

2. Press the id key.

3. To recall the ID number, press display id.

NOTE: a. The ID number you have entered will be assigned to all batches until a new ID number is

entered or the reset key is pressed. To clear an ID number, press the — id keys.

b. If an ID number of more than six digits is used, the scale will display the last six digits

entered, but will store and print the entire number (up to its limit of 25 digits). For example,

if 123456789 is entered, the scale will display 456789, but will store and print 123456789

(as explained in “Printing Out Information”).

c. The — key may serve as a dash (hyphen) during ID number entry. Simply press the —

key wherever you wish to insert a dash (you may use as many dashes as you need,

however, no more than one dash may be used consecutively).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 72 73

Pas de commentaire

Setra Systems Super Count Spécifications Page 16