Setra Systems Super II Manuel d'utilisateur télécharger pdf (Page 11)

10 Introduction • Super II

Understanding Your Scale

Keypad: Soft Keys

The Super II keypad is divided into three groups of keys. The first set of keys underneath the display are

referred to as “soft keys”. Their function changes depending on where you are in the counting procedure

or which level you enter in the menu.

The default soft keys are listed below and have the following functions:

ZERO Assigns the pan and whatever is currently being weighed a value of zero. While the

scale is determining a stable weight reading, the display will indicate “Zero Base

Process Activated”. A zeroing operation underway can be cancelled with a second pass of

the ZERO key.

Note: If a Tare value is stored in memory, it will be cleared.

SAMPLE Determines a stable reference point and displays the preprogrammed sample sizes

(10, 25, 50, 100 pieces). A SAMPLE size selection menu can be displayed if activiated in

the Supervisor setups (see SAMPLE soft key in the “Supervisor and Technical Setups

Manual”.

COUNT Instructs the scale to begin or resume counting.

PRINT Instructs the scale to print preprogrammed fields or label format. If multiple label

formats are active, a print menu is displayed in order to make a numeric

print register selection.

CLEAR Used to switch from Count (pieces) to Weight.

LRG SPL Used to go to the next programmed sample size. For example, to go from “ADD 10

PIECES” to “ADD 25 PIECES”.

UPDTAPW Used to recalulate the APW based on a larger sample size. The additional sample

weight cannot exceed 100% of the previous sample to avoid the compounding of

errors (see Counting with Accuracy Enhancements in this User Manual).

EXIT Returns the display to either Weight or Count(pieces) depending on which was last

active before the menu prompt.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Pas de commentaire

Setra Systems Super II Manuel d'utilisateur Page 11